Exchange in 3 steps
-
Set the SOL amount and paste your MetisDAO payout address on Metis mainnet.
-
Create the order to lock the quote and see the deposit address.
-
Send SOL to that deposit. After confirmations, METIS is paid to your wallet.
Before you broadcast
- Solana confirmations are fast — often under a minute for practical purposes.
- Network outages or congestion can occasionally delay inclusion — check status if stuck.
- Use a Solana mainnet address (base58). Do not send SPL tokens unless the order specifies a token mint.
- METIS not visible yet? Wait a few minutes, resync your wallet, then contact support with your order ID if the payout tx is already listed.
Solana — high-speed layer-1
SOL is the native token of Solana — built for fast, low-cost transfers and a large ecosystem of on-chain apps.
Solana deposit tips
Send native SOL on Solana mainnet. Token deposits require the exact asset your order lists.
Keep a small SOL balance for rent-exempt account requirements in some wallets.
MetisDAO
Always match METIS on Metis mainnet when you send or receive — wrong-network transfers may not be credited.
Receiving METIS
Your wallet must be on Metis mainnet.
Allow a few minutes after the order shows sent before opening support.
Before you swap
Avoid wrong-network deposits and address format mistakes — read these guides first.
Coin swap hubs
More no-KYC swap pairs and guides for each asset.
Frequently asked questions
Is identity verification required to trade SOL for METIS?
No. HideSwap operates as an anonymous no-KYC crypto exchange — no profile, no ID upload, and no funded account for Solana → MetisDAO.
How long is a SOL → METIS order?
Typical completion is a few minutes. Solana mainnet and Metis mainnet confirmation times set the pace.
Do you custody SOL or METIS?
No. You send SOL yourself and METIS is paid to the address you enter — HideSwap does not keep a wallet balance for you.
What if I pick the wrong SOL network?
Match the network printed on the order (Solana mainnet). A mismatch can strand the deposit — check the swap safety notes first.